Edit and preserve a 3D CAD draft

Set a box and subtracting cylinder, read build status and preserve the editable feature document.

3D CAD keeps an editable feature document. Feature parameters, a successfully calculated mesh and saved PCB assembly geometry are separate results.

Enter the plate and cylinder dimensions

  1. In the ALcad window, expand its flows → ALcad → 3D CAD and choose Add box.

  2. In Feature properties, set Dimensions (mm) X, Y and Z to 40, 30 and 6. Check Center (mm) 0, 0 and 3, then choose Apply dimensions.

  3. Choose Add cylinder. Set Diameter to 8, Height to 10 and Center (mm) X, Y and Z to 0, 0 and 3.

  4. Set Operation to Subtract and choose Apply dimensions. Check that the feature list shows the box followed by the subtracting cylinder.

Add box: Dimensions (mm) 40, 30 and 6 at Center (mm) 0, 0 and 3.

Add box: Dimensions (mm) 40, 30 and 6 at Center (mm) 0, 0 and 3.

Subtracting cylinder: Diameter 8, Height 10, Center (mm) 0, 0 and 3.

Subtracting cylinder: Diameter 8, Height 10, Center (mm) 0, 0 and 3.

Read the build result

Solid could not be built means that no successful mesh has been established. The feature list and input dimensions remain editable. Rebuild solid retries calculation; a failed retry does not confirm a hole, volume, surface area or clearance.

Keep the editable document

  1. Choose Download solid in the 3D CAD toolbar to keep the editable .alcad-solid.json document. Hover a toolbar icon to read its label.

  2. Choose Open solid in the same toolbar and select that downloaded document.

  3. Check the reopened feature list and each feature’s applied dimensions. Reopening the document confirms its editable parameters, not a successful geometry calculation.

Choose Download solid in the 3D CAD toolbar to keep the editable document.

Choose Download solid in the 3D CAD toolbar to keep the editable document.

Check the reopened feature list and the applied dimensions.

Check the reopened feature list and the applied dimensions.

When a host offers a valid mesh, mesh export depends on the available output controls. Units, orientation and scale must be checked in the receiving tool. A mesh does not preserve all editable feature history. Project save and board 3D Assembly are separate host capabilities; no PCB placement or mechanical fit follows from a solid draft.

If calculation fails

Preserve editable JSON before leaving the browser or moving devices. Check feature order, dimensions, centers and operation. A subtracting feature can remove the whole base. Change one parameter at a time; judge the result only after the displayed build succeeds.

Related guides

PCB editing · Circuit editing · Update and move